Mark-Haebler-Quick-Lock-TME25-Presentation.pdf

《Mark-Haebler-Quick-Lock-TME25-Presentation.pdf》由会员分享，可在线阅读，更多相关《Mark-Haebler-Quick-Lock-TME25-Presentation.pdf（37页珍藏版）》请在三个皮匠报告上搜索。

1、Quick-LockUhrig Kanaltechnik GmbHPRESSURE PIPE8.Quick-LockPRESSURE PIPELD+HDQuick-Lock PRESSURE PIPE LD(low duty)permissible static pressure-0.9 bar to 50 bar/-13.05 psi to 725.19 psi permissible dynamic pressure-0.4 bar to 3 bar/-5.80 psi to 43.51 psiWhen using the Quick-Lock sleeve(non-walkable ar

2、ea)in pressurized pipelines(internal pressure),the pressure resistance can always only be guaranteed in conjunction with the use of a protector shield(around the outside of the seal).The protector shield prevents the seals from creeping into any gaps or fissures in the pipe.Quick-Lock PRESSURE PIPE

3、HD(heavy duty)permissible static pressure-0.9 bar to 50 bar/-13.05 psi to 725.19 psi permissible dynamic pressure-0.9 bar to 10 bar/-13.05 psi to 145.04 psiWhen using the Quick-Lock sleeve(non-walkable area)in pressurized pipelines(internal pressure),the pressure resistance can always only be guaran

4、teed in conjunction with the use of a protector shield(around the outside of the seal).The protector shield prevents the seals from creeping into any gaps or fissures in the pipe.Which pipe materials are suitable?all pipe materials used for pressurized piplines,likeQuick-Lock is conditionally suitab

5、le in the following cases:Pipes with bends and fittingsPlastic pipes(all types,like f.e.PVC,PE,PP,PP-HD,)Fiberglass pipes and CIPPCast iron pipesCarbon Steel pipesUhrig Kanaltechnik GmbHComponents of the Quick-Lock PRESSURE PIPEUhrig Kanaltechnik GmbHStainless steel sleeveRubber sealProtector shield

6、1.Flared ends(only build B2)2.metal overlap3.Gear rack4.locking mechanism5.tape(HD blue,LD yellow)6.plastic pin7.sealing nubs8.parting line9.overlapping rubber(mandatory cut at parting line)Protector shield is mandatoryFlared EndsFlaring is the bending of both ends of the Quick-Lock PRESSURE PIPE wi